Point-To-Point Mode - Garmin GTN 750 Pilot's Manual

15.4.1
Foreword
The Trip Planning Point-to-Point mode shows trip calculations between two
selected points: either two waypoints from the database or from your present
Getting
Started
position to a selected waypoint.
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Touch To Use
Present Position
Map
As Departure
Traffic
Touch To Select
Departure Time
Terrain
Touch To Select
Departure Date
Weather
Nearest
Music
Utilities
System
Messages
Symbols
Appendix
15-14
Index

Point-To-Point Mode

1. While viewing the Utilities page, touch the Trip Planning
key.
2. Touch the Mode key to toggle to Point-to-Point.
3. Touch the P.POS key to toggle between using your present
position as the From waypoint when selected or a waypoint
selected from the database when P.POS is deselected. If P.POS
is selected, the Lat/Lon of the present position will be shown
in the From position.
Lat/Lon Of Present
Point
Figure 15-14 Utility Trip Planning Page (Point-To-Point Mode)
4. If P.POS is not selected for the From point, touch the From
key and then use the keypad to select a waypoint from the
database and touch Enter.
Garmin GTN 725/750 Pilot's Guide
Touch To Select
Position Arrival Waypoint
Touch To Select
P-to-P or Flight
Plan Mode
Touch To Select
Expected Average
Ground Speed
Trip Statistics
190-01007-03 Rev. B