Figure H-40. Gtn 6Xx/7Xx Crossfill Interconnect - Garmin GPS 400W Installation Manual

GNS 400W SERIES
GPS RS232 OUT 3
5
GPS RS232 IN 3
NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS:
3. AT THE GNS 400W, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL -- THE SHIELD LEADS
MUST BE LESS THAN 3.0". CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT GROUND WITH AS SHORT A
CONDUCTOR AS PRACTICAL.
4. REFERENCE SECTION 5 FOR RS-232 CONFIGURATION.
5. IF A GTN AND GNS 400W ARE INSTALLED, THE RS-232 LINES MAY BE CONNECTED TO CROSSFILL FLIGHT
PLANS AND USER WAYPOINTS FROM THE GTN TO THE GNS 400W. THE GTN MUST HAVE SOFTWARE
VERSION 3.00 OR LATER INSTALLED. THE GNS 400W MUST HAVE SOFTWARE VERSION 5.00 OR LATER
INSTALLED.
6. ANY AVAILABLE RS-232 PORT CAN BE USED IN LIEU OF PORT 3 ON THE GTN.
7. THE CONNECTED GNS RS-232 PORT MUST BE SET TO 'GTN CROSSFILL' AND THE GTN RS-232 PORT MUST
BE SET TO 'GNS CROSSFILL'.
Page H-52
Rev. G
GNS 400W Series – GTN 6XX/7XX Crossfill
P4001
41
42
SHIELD BLOCK GROUND

Figure H-40. GTN 6XX/7XX Crossfill Interconnect

7
s
AIRFRAME GROUND
s
GNS 400W Series Installation Manual
GTN 6XX/7XX
P1001
6
25 RS-232 IN 3
6 RS-232 OUT 3
5
44 RS-232 GND 3/4
190-00356-08