Connecting To An Ethernet Network; Attaching A Network Cable To The Rj-45 Connector - Compaq AP200 - Professional - 128 MB RAM Reference Manual

5-2 Network Communications

Connecting to an Ethernet Network

An RJ-45 Ethernet network connector is included on your workstation.
Attaching a Network Cable to the
RJ-45 Connector
Refer to the following illustration to connect a network cable to the RJ-45
connector.
Figure 5-1. Attaching the network cable to the RJ-45 connector
IMPORTANT: If you are connecting to a 100BaseTX network, you must use
a Category 5 UTP cable. Also, in order for Remote Wakeup and Remote
Shutdown to function, the internal power cable for the network interface
controller must be connected to the system board. See the section "Remote
Wakeup and Remote Shutdown" in Chapter 3 for information on these
features.
WARNING: To reduce the risk of injury from
electrical shock, remove all power cords to
completely disconnect power from the system
before attaching the network cable to the RJ-45
connector.