Table of Contents
Advertisement
4-28
Hardware Upgrades
4.
Insert the drive into the adapter so that the guide screw aligns in the slot,
and then attach with two retaining screws.
5.
Snap on the brace.
Figure 4-20.
6.
Install two guide screws on each side of the adapter.
7.
Install the adapter in the desired drive bay by sliding it into the front of
the drive cage; the drivelock automatically secures the adapter when it
snaps into place.
NOTE: The primary 3.5-inch diskette drive should only be installed into bay 3.
Bay 3 is the bottom bay in the minitower configuration and the topmost bay in
the desktop configuration.
Attaching a 3.5-Inch Drive to the 5.25-Inch Adapter
Advertisement
Table of Contents
Troubleshooting
