4-30
Hardware Upgrades
Figure 4-23. Connecting the drive cables to the system board: 1 IDE diskette drive connector,
9.
If necessary, remove the bezel blank from the subpanel inside the front
bezel. See the section "Removing the Bezel Blank."
10. Replace the workstation access panel.
11. Plug the network cable back into the system. Plug the power cord back
into the grounded AC outlet. Reconnect external devices.
12. Reconfigure the workstation, if necessary. See the "When to
Reconfigure the Workstation" section in this chapter.
2 IDE Ultra ATA hard drive connector 3 IDE CD-ROM connector
1
2
3