Compaq AP200 - Professional - 128 MB RAM Reference Manual page 28

Using Computer Setup
To access the Computer Setup utilities menu, complete the following steps:
1. Turn on or restart the workstation. If you are in Windows, click Start,
then Shut Down. Restart the workstation.
2. When the F10 Setup message appears in the lower-right corner of the
screen, press the F10 key.
NOTE: If you do not press the F10 key while the message is displayed, you
must turn the workstation off, then on again, to access the utility. The F12 key
initiates Network Service Boot for Remote System installation. See Chapter 3
of this guide for more information about this feature.
3. Press Enter to bypass the title. The Setup Utilities menu appears.
A choice of five headings appears in the Setup Utilities menu: File,
Storage, Security, Power, and Advanced.
4. Using the arrow keys or the Tab key, select the option you want and
press the Enter key. To return to the Setup Utilities menu, press the Esc
key.
5. To apply and save changes, select File, then Save Changes and Exit. If
you selected an option that automatically restarted the workstation,
changes were applied at that time. If you have made changes that you do
not want applied, select Ignore Changes and Exit. If you have already
applied changes you now want to eliminate, select Set Defaults and Exit.
This option will restore the original system defaults.
Compaq Professional Workstation AP200 Reference Guide
2-3