Compaq AP200 - Professional - 128 MB RAM Reference Manual page 87

Turn on an external SCSI device before turning on power to the
workstation. This enables the system board controller to recognize the
external SCSI device. When an external SCSI device is connected to
the external SCSI connector on the rear panel of the workstation, that
device becomes the end of the SCSI chain and must be terminated.
CAUTION: Do not route cables near the air intake to the power
supply. Cables routed in this manner may block airflow to the
power supply causing it to overheat.
Using the SCSI Cable
The following SCSI cable is included with your workstation (available on
select models):
1
Figure 4-16. SCSI cable
NOTE: The SCSI cable included with your workstation may look slightly
different than the one pictured.
The SCSI cable illustrated above supports up to 4 SCSI devices and comes
with a terminator 1 on the end.
NOTE: If you are installing a narrow SCSI device, you will need to attach a
68- to 50-pin SCSI adapter to the narrow SCSI device.
For additional information about installing optional SCSI devices, refer to the
documentation included with the device option kit or contact your Compaq
authorized dealer, reseller, or service provider.
Compaq Professional Workstation AP200 Reference Guide
4-23