Connecting To An Ethernet Network; Installing The Network Driver - Compaq SP700 Reference Manual

4-2 Network Communications

Connecting to an Ethernet Network

An RJ-45 Ethernet network connector is included on your workstation.
Refer to the following illustration to connect a network cable to the RJ-45
connector.
Figure 4-1. Attaching the network cable to the RJ-45 connector

Installing the Network Driver

The network device driver enables the workstation to communicate with the
network. The network driver is preinstalled on your workstation. For
information about installing the driver, operating system, and other support
software, see the Software Installation Guide.
IMPORTANT: If you are connecting to a 100BaseTX network, you must use
a Category 5 UTP cable.
Any RJ-45 receptacle marked with these symbols indicates
a Network Interface Connection.
WARNING: To reduce risk of electrical shock, fire, or
damage to the equipment, do not plug telephone or
telecommunications connectors into this receptacle.