Solving Scsi Problems - Compaq AP200 - Professional - 128 MB RAM Reference Manual

Solving Disk Problems
Problem
Second IDE Ultra ATA
hard drive does not
perform optimally
Nonsystem disk
message

Solving SCSI Problems

If you encounter SCSI device problems, refer to the common causes and
solutions listed in the following table.
System with IDE and SCSI
drives will not boot from SCSI
hard drive
System will not boot from a
SCSI drive
Continued
Cause
You are using the wrong
cable for the drive type.
The system is trying to start
from a nonsystem diskette.
Solving SCSI Problems
Problem
The IDE drive is not disabled
through the Configuration utility.
Compaq does not support mixing
IDE Ultra ATA and SCSI hard drives
in the same system.
The SCSI drive is not configured
correctly.
Reinstall the second IDE Ultra ATA hard
drive using an 80-conductor cable. This
cable comes in the drive option kit.
Remove the diskette from the drive.
Table 6-3
Cause
Compaq Professional Workstation AP200 Reference Guide
Solution
Solution
Under the Computer
Setup Advanced
menu, disable the
primary IDE
controller.
Ensure that drive
cabling and jumpers
are set correctly. To
boot a SCSI drive,
the drive ID number
must be set to 0.
6-7