Compaq AP200 - Professional - 128 MB RAM Reference Manual page 118

6-16 Troubleshooting
Solving Network Problems
Diagnostics passes, but
the workstation does not
communicate with the
network ( continued )
Network controller
stopped working when an
expansion board was
added to the workstation
Network controller
stopped working without
apparent cause
Cannot connect to
network server when
attempting Remote
System Installation
Continued
Problem
The network controller is not
configured for this
workstation.
Network controller interrupt
with an expansion board.
The network controller
requires driver.
The files containing the
network driver are
corrupted.
The files containing the
network driver are
corrupted.
The cable is not securely
connected.
The network controller is
defective.
The network controller is not
configured properly.
Cause
Select the Network icon at the
Control Panel.
Under the Computer Setup
Advanced menu, change the
resource settings for the
board.
Verify that the driver was not
accidentally deleted when the
drivers for a new expansion
board were installed.
Reinstall the network driver,
using the Compaq SmartStart
for Workstations CD.
Reinstall the network driver,
using the Compaq SmartStart
for Workstations CD.
Ensure that the cable is
securely attached to the
network connector and that
the other end of the cable is
securely attached to the
correct device.
Contact your Compaq
authorized service provider.
Run Computer Setup and
modify the Embedded NIC
Settings.
Solution