4-26
Hardware Upgrades
3.
Install the drive in the desired drive bay by sliding it into the front of
the drive cage; the drivelock automatically secures the drive in the bay.
NOTE: Be sure the guide screws line up with the guide slots in the drive cage.
Figure 4-17.
4.
Connect the drive power and signal cables and, if it is a CD-ROM
drive, connect the audio cable. The other end of the audio cable should
be connected to the optional audio board, if installed.
Figure 4-18.
Aligning the guide screws and installing an optional 5.25-inch drive
Connecting the drive cables to the drive