Removing The Workstation Access Panel - Compaq AP200 - Professional - 128 MB RAM Reference Manual

If configuration settings are incorrect, one or more devices may not work
properly, and you may receive an error message. If this occurs, run the
Computer Setup utility again. See Chapter 2 of this guide for more
information on Computer Setup.
Removing the Workstation Access
Panel
1. Turn off the workstation and any external devices.
2. Disconnect the power cord from the grounded AC outlet, the network
cable from the system, and disconnect any external devices.
3. Remove the two screws that secure the access panel to the workstation
chassis.
4. Slide the access panel back about 1 inch (2.5 cm), then lift it off the
unit.
Figure 4-1.
To replace the access panel, reverse steps 1–4.
CAUTION: Before removing the workstation access panel,
ensure that the workstation is turned off and that the power cord
is disconnected from the grounded AC outlet.

Removing the workstation access panel

Compaq Professional Workstation AP200 Reference Guide
4-3