Platform_Vlan Messages - Cisco 3845 - Security Bundle Router Manual

PLATFORM_VLAN Messages

Error Message PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could not
be programmed into TCAM and are being covered by a less specific prefix
PLATFORM_VLAN Messages
Error Message PLATFORM_VLAN-3-LOCK_FAIL: Failed to lock vlan-id [dec], associated
mapped vlan id value [dec].
Error Message PLATFORM_VLAN-3-MVID_ERROR: Mapped Vlan ID value [dec] associated with
vlan-id [dec] is invalid.
Error Message PLATFORM_VLAN-3-UNLOCK_FAIL: Failed to unlock vlan-id [dec],
associated mapped vlan id value [dec].
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-38
Explanation A more specific prefix could not be programmed into TCAM and is covered by a less
specific prefix. This could be a temporary condition. The output of the show platform ip unicast
failed route privileged EXEC command lists the failed prefixes.
Recommended Action No action is required.
The VLAN lock operation failed. This can occur if the VLAN is already active in the
Explanation
system or if the VLAN ID is not active. The first [dec] is the VLAN ID, and the second [dec] is the
mapped-vlan-id (MVID).
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
An active VLAN is not correctly associated with a mapped-vlan-id (MVID). The first
Explanation
[dec] is the VLAN ID, and the second [dec] is the MVID.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
The switch did not unlock a VLAN ID. The most likely cause is that the VLAN is
Explanation
already unlocked. The first [dec] is the VLAN ID, and the second [dec] is the MVID.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
Chapter 2 Messages and Recovery Procedures
"Error Message Traceback Reports" section on
"Error Message Traceback Reports" section on
"Error Message Traceback Reports" section on
OL-23408-01