Spantree_Fast Messages; Spantree_Vlan_Sw Messages - Cisco 3845 - Security Bundle Router Manual

SPANTREE_FAST Messages

Error Message SPANTREE-7-RECV_1Q_NON_TRUNK: Received 802.1Q BPDU on non trunk
[chars] [chars].
SPANTREE_FAST Messages
Error Message SPANTREE_FAST-7-PORT_FWD_UPLINK: [chars] [chars] moved to Forwarding
(UplinkFast).

SPANTREE_VLAN_SW Messages

Error Message SPANTREE_VLAN_SW-2-MAX_INSTANCE: Platform limit of [dec] STP instances
exceeded. No instance created for [chars] (port [chars]).
Error Message SPANTREE_VLAN_SHIM-3-ADD_REGISTRY_FAILED: Subsystem [chars] fails to
add callback function [chars]
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-64
Explanation An SSTP BPDU was received on the listed interface, which is not an operational
trunking interface. The first [chars] is the port name, and the second [chars] is the VLAN name.
Verify that the configuration and operational state of the listed interface and
Recommended Action
that of the interface to which it is connected are in the same mode (access or trunk). If the mode is
trunk, verify that both interfaces have the same encapsulation (none or 802.1Q). When these
parameters are consistent, spanning tree automatically unblocks the interface.
the listed interface has been selected as the new path to the root switch for the listed
Explanation
spanning-tree instance. The first [chars] is the spanning-tree instance, and the second [chars] is the
interface.
No action is required.
Recommended Action
Explanation The number of currently active VLAN spanning-tree instances has reached a
platform-specific limit. No additional VLAN instances are created until the existing number of
instances drops below the platform limit. [dec] is the spanning-tree instance limit, first [chars] is the
smallest VLAN number of those VLANs that cannot have spanning-tree instances created, and
second [chars] is the port number.
Reduce the number of currently active spanning-tree instances by either
Recommended Action
disabling some of the currently active spanning-tree instances or deleting the VLANs associated
with them. You must manually enable the spanning trees that could not be created because of limited
instances.
Explanation A subsystem did not add its callback functions. Use this message only for debugging.
The first [chars] is the subsystem name, and the second [chars] is the function name.
Recommended Action No action is required.
Chapter 2 Messages and Recovery Procedures
OL-23408-01