Badtransceiver Messages; Bspatch Messages - Cisco 3845 - Security Bundle Router Manual

BADTRANSCEIVER Messages

BADTRANSCEIVER Messages
Error Message BADTRANSCEIVER, PHY, LOG_WARNING: An innapropriate transceiver has
been inserted in interface [chars].

BSPATCH Messages

Error Message BSPATCH-1-RELOAD: System will reboot to activate newly patched Boot
Loader.
Error Message BSPATCH-1-PATCHED: Boot Loader patch ([chars]) installed.
Error Message BSPATCH-3-FAILED: Failed to install Boot Loader patch ([chars]).
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-8
A defective module is installed in the specified interface. [chars] is the interface.
Explanation
Remove the transceiver. If it was purchased from Cisco, contact your Cisco
Recommended Action
representative to have the transceiver replaced.
The switch automatically reboots after the boot loader is patched.
Explanation
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC,
or provide your Cisco technical support representative with your information. For more information
about these online tools and about contacting Cisco, see the
section on page 1-5.
A boot loader patch installed successfully. [chars] is the SDRAM refresh timer register
Explanation
setting.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still need assistance, open a case with the TAC,
or provide your Cisco technical support representative with your information. For more information
about these online tools and about contacting Cisco, see the
section on page 1-5.
The switch did not apply a boot loader patch. [chars] is the SDRAM refresh timer
Explanation
register setting.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
Chapter 2 Messages and Recovery Procedures
"Error Message Traceback Reports"
"Error Message Traceback Reports"
"Error Message Traceback Reports" section on
OL-23408-01