Platform_Vlan Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message PLATFORM_UCAST-3-RPC: [chars].
Error Message PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could not
be programmed into TCAM and are being covered by a less specific prefix

PLATFORM_VLAN Messages

This section contains platform VLAN messages.
Error Message PLATFORM_VLAN-3-LOCK_FAIL: Failed to lock vlan-id [dec], associated
mapped vlan id value [dec].
Error Message PLATFORM_VLAN-3-MVID_ERROR: Mapped Vlan ID value [dec] associated with
vlan-id [dec] is invalid.
OL-9641-04
This message means that the RPC module for unicast routing encountered an error.
Explanation
[chars] describes the error.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Explanation A more specific prefix could not be programmed into Ternary Content Addressable
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ip unicast failed route privileged EXEC command lists the failed
prefixes.
No action is required.
Recommended Action
Explanation This message means that the VLAN lock operation failed. This can occur if the VLAN
is already active in the system or if the VLAN ID is not active. The first [dec] is the VLAN ID, and
the second [dec] is the mapped-vlan-id (MVID).
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
Message Traceback Reports" section on page
Explanation This message means that an active VLAN is not correctly associated with a
mapped-vlan-id (MVID). The first [dec] is the VLAN ID, and the second [dec] is the MVID.
Copy the message exactly as it appears on the console or in the system log.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
1-3.
1-3.
PLATFORM_VLAN Messages
"Error
"Error
2-47