Platform_Pbr Messages - Cisco 3845 - Security Bundle Router Manual

PLATFORM_PBR Messages

PLATFORM_PBR Messages
Error Message PLATFORM_PBR-2-NO_RMAP: Cannot create PBR data structures for
route-map [chars].
Error Message PLATFORM_PBR-3-INSTALL_FAIL: Policy route-map [chars] not installed in
hardware.
Error Message PLATFORM_PBR-3-NO_LABEL: Cannot allocate label for route-map [chars].
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing.
Error Message PLATFORM_PBR-4-CPU_SUPPORTED_ACTION: Set action in sequence [dec] of
route-map [chars] supported by forwarding to CPU.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-34
The policy based routing (PBR) manager could not allocate the internal data structures
Explanation
for this route-map. A likely cause is lack of available memory. [chars] is the route-map.
Simplify the configuration so that it requires less memory.
Recommended Action
The PBR manager could not install the complete route-map in hardware, so the packets
Explanation
are forwarded to the CPU for processing. [chars] is the route-map.
Simplify route-map configurations. For example, use the same route-map on
Recommended Action
multiple interfaces.
Explanation The PBR manager could not allocate a label for this route-map. As a result, the hardware
cannot be programmed to implement policy routing. There is a limit of 247 labels for policy routing.
[chars] is the route-map.
Recommended Action Simplify the configuration with label sharing. Use the same route-maps on
multiple interfaces, if possible.
The route-map attached to an interface for policy routing contains an action that is not
Explanation
supported. This is a hardware limitation. [chars] is the route-map.
Recommended Action Use the route-map map-tag permit global configuration command and the set
ip next-hop ip-address route-map configuration command to reconfigure the route map to use only
these supported actions.
The route-map attached to an interface for policy-based routing contains an action that
Explanation
is not supported in hardware, so the packets are forwarded to the CPU for processing. The route-map
actions that invoke this forwarding are set interface, set ip default next-hop, set default interface,
or set ip df. [dec] is the action number, and [chars] is the route-map.
Use the set ip next-hop ip-address route-map configuration command to
Recommended Action
reconfigure the route map action to route the packet to the specified next hop.
Chapter 2 Messages and Recovery Procedures
OL-23408-01