Platform_Pbr Messages - Cisco IAD2423-16FXS-RF - IAD 2423 Router System Message Manual

PLATFORM_PBR Messages

PLATFORM_PBR Messages
This section contains policy based routing (PBR) messages.
These messages apply only to the Cisco ME 3400E and ME 3400 switches.
Note
Error Message PLATFORM_PBR-2-NO_RMAP: Cannot create PBR data structures for
route-map [chars].
Error Message PLATFORM_PBR-3-INSTALL_FAIL: Policy route-map [chars] not installed in
hardware.
Error Message PLATFORM_PBR-3-NO_LABEL: Cannot allocate label for route-map [chars].
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
2-42
This message means that the PBR manager could not allocate the internal data structures
Explanation
for this route-map. A likely cause is lack of available memory. [chars] is the route-map.
Simplify the configuration so that it requires less memory.
Recommended Action
This message means that the PBR manager was unable to install the complete route-map
Explanation
in hardware, so the packets are forwarded to the CPU for processing. [chars] is the route-map.
Simplify route-map configurations. For example, use the same route-map on
Recommended Action
multiple interfaces.
Explanation This message means that the PBR manager could not allocate a label for this route-map.
As a result, the hardware cannot be programmed to implement policy routing. There is a limit of 247
labels for policy routing. [chars] is the route-map.
Simplify the configuration with label sharing. Use the same route-maps on
Recommended Action
multiple interfaces, if possible.
This message means that the route-map attached to an interface for policy routing
Explanation
contains an action that is not supported on this platform. This is a hardware limitation. [chars] is the
route-map.
Use the route-map map-tag permit global configuration command and the set
Recommended Action
ip next-hop ip-address route-map configuration command to reconfigure the route map to use only
these supported actions.
Chapter 2 Messages and Recovery Procedures
OL-9641-04