For Front Rack Access; Attaching The Outer Slide Rails To The Hp 9000 Series Rack - HP StorageWorks SAN Switch 2/32 Installation Manual

4. Repeat steps 1 through 3 to install the left mount bracket on the left side of the
switch, see Figure 2–3.

For Front Rack Access

Use these steps to attach the front rack mount brackets to the switch. The front rack
mount brackets act as "stops" to prevent the switch from sliding out the front of the
rack. Use these steps if you installed the inner slide rails to the switch using the
procedure outlined in "Attaching the Inner Slide Rails to the Switch," step 1b.
1. Align the right rack mount bracket with the two screw holes at the end of the inner
rails on the right, power supply end of the switch.
2. Locate two slotted head Phillips head 8-32 x 3/8 in screws and two lock nuts
contained in the Rack Mount Kit accessory pouch.
3. Secure the right mount bracket to the end of the inner slide rail using the screws
and lock nuts.
4. Tighten the screws and torque to 15 inch-pounds.
5. Repeat steps 1 through 4 to install the left mount bracket onto the second inner
slide rail.

Attaching the Outer Slide Rails to the HP 9000 Series Rack

Use the following steps to install the outer slide rails in the HP 9000 Series Rack.
NOTE: This procedure requires two technicians to properly align the outer slide rails in the HP
9000 Series Rack.
Obtain the following items, located in the Rack Mount Kit:
• Four 3-hole bar nuts
• Eight Phillips head 8-32 x 3/8-inch screws
• Eight square alignment washers
• # 2 Phillips screwdriver with torque capability
SAN switch 2/32 version 4.0.x installation guide
Installing the SAN Switch 2/32
2–11 2–11