Installing Additional Memory - HP D5970A - NetServer - LCII Installation Manual

Chapter 5

Installing Additional Memory

The HP NetServer must be powered down to install additional memory, but it
does not require sliding the HP NetServer out of the rack.
1. Log off all users and if necessary, back-up files.
2. Follow instructions in Chapter 3, "Opening and Closing the HP
NetServer," to shutdown your respective NOS.
NOTE
The power supplies continue to provide standby current to the
HP NetServer until the power cable is disconnected.
3. Disconnect the power cord from the power strip.
4. Swing the front bezel open, or remove it entirely.
Refer to Chapter 3, "Opening and Closing the HP NetServer" for details.
5. At the front of the HP NetServer, locate the LCD display and the memory
bay cover, just below it. See Figure 5-3.
On top of the LCD display's housing is a small handle used to raise or
lower the LCD display. The memory bays are concealed and protected by
the memory bay cover.
6. Loosen the three captive screws holding the memory bay cover in place.
See Figure 5-3.
7. Pull up on the LCD handle with one finger to allow for movement of the
memory bay cover. See Figure 5-3.
The LCD display should move up about ½ inch and stop. See Figure 5-3.
NOTE
If you do not push the LCD display up and out of the way, you
cannot remove the memory bay cover.
8. Remove the memory bay cover from the HP NetServer. See Figure 5-3.
The memory boards are located side by side underneath the processor tray
assembly.
52
Installing Additional Memory