Installing Additional Memory - HP DL360 - ProLiant - G3 Setup And Installation Manual

Table 2-1: System Board Connectors and Components
Item Description
1 PCI riser board slot 1 connector
2 Battery
3 DIMM slots (four)
4 Processor Power Module (PPM)
socket 1 (shown with PPM installed)
5 Processor 1 socket (shown with
processor/heatsink installed)
6 Processor 2 socket
7 Fan board connector
8 SCSI board connector
9 Optical device/floppy board signal
connector

Installing Additional Memory

Server memory can be expanded by installing Double Data Rate Synchronous
DRAM (DDR SDRAM). The system supports up to four PC2100 ECC registered
DDR SDRAM Dual Inline Memory Modules (DIMMs) installed in four sockets on
the system board. Memory must be added two equivalent modules at a time.
Refer to Figure 2-4 and to Table 2-1 for DIMM slot location and socket numbers.
This information is also available on the hood label. Memory must be installed in the
lowest DIMM socket number to the highest.
The following guidelines must be observed when installing additional memory:
•
DIMMs installed in the server must be PC2100 registered DDR SDRAM, 3.3 V,
64 bits wide, and ECC.
HP ProLiant DL360 Generation 3 Server Setup and Installation Guide
Item Description
10 Power signal connector
11 System power connector
12 PPM socket 2
13 Smart Array 5i memory connector
14 Debug LED switch bank (SW3)
15 Redundant Power Supply/PCI install
switch bank (SW1)
16 PCI riser board slot 2 connector
17 System maintenance switch (SW2)
Installing Hardware Options
2-7