HP D5970A - NetServer - LCII Installation Manual page 78

Chapter 6
Ensure
PCI hold-down
latch is at least half open
before inserting board.
Figure 6-6. Installing the Accessory Board
13. Close the PCI hold-down latch by pushing it in from the rear of the HP
NetServer until it clicks. See Figure 6-7.
The PCI hold-down latch should click when you push it into place.
14. Close the latch on the PCI board guide. See Figure 6-7.
15. If the installed accessory board requires an external connection or a
connection to the I/O baseboard, ensure the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
70
Installing Additional Boards
Insert board