Error Codes And Messages - HP D5970A - NetServer - LCII Installation Manual

Chapter 12
5. Press F10 to save the configuration changes and exit.
The HP NetServer reboots and the processor should be re-enabled.

Error Codes and Messages

This section provides the error codes and messages occurring during POST
(Power-On Self Test) and normal operation. The error codes and messages appear
on the front control panel's LCD display.
l
POST Codes – The POST (Power-On Self-Test) codes occur during POST
diagnostics and will display a coded error message if an error condition is
encountered during the boot process. These codes will also appear on the
display monitor, provided it and the supporting circuitry are functioning.
l
Error Messages – The error messages occur during normal operation. If
you get an error message, refer to Table 12-2 later in this chapter. You may
also use the following utility to find the error conditions.
Run the Event Log Report Utility.
NOTE
For a complete list of error messages and solutions refer to
Information Assistant on the HP NetServer Online
Documentation CD-ROM for the HP NetServer LXr 8500. HP
Information Assistant runs on a HP Vectra or other PC running
Windows 3.1 and above, Windows 95, 98, or Windows NT.
Troubleshooting
139