Processor Installation - HP D5970A - NetServer - LCII Installation Manual

Chapter 7
4 Processor
Modules
Processor Cage
Locking Bar (4)
Left Processor
Carrier Board

Processor Installation

NOTE
The following steps assume the HP NetServer is already in a
rack. Ensure you unplug power from the HP NetServer before
pulling it forward on its slides.
If you have space in the rack over the HP NetServer, you may
be able to install/remove processor modules without pulling the
chassis out of the rack.
1. Perform the shutdown procedure listed in Chapter 3, "Opening and Closing
the HP NetServer" for the respective NOS.
NOTE The power supplies will continue to provide standby current to
the HP NetServer until the power cable is disconnected.
80
1 Processor
Module (min)
J6A1 Jumper Block
Figure 7-3. 8-Way Configuration
Installing Additional Processors
Right Processor
Carrier Board
Both Cache Coherency
Filters Installed
(required for 8-way)