HP D5970A - NetServer - LCII Installation Manual page 62

Chapter 5
A. Pull open retaining
latches on memory
board.
10. Hold the memory board by the corners and carefully pull the board from its
slot. See Figure 5-4.
NOTE If you need to remove both memory boards, repeat Steps 2 and
3 for the other board.
11. Place the memory board, component-side up, on a firm anti-static surface
for protection.
NOTE
The component-side of the memory board must be face-up and
rest on a firm surface to apply pressure to the DIMM.
54
DIMM installed
on underside
of board.
Figure 5-4. Removing a Memory Board
Installing Additional Memory
Retaining
Latches
B. Pull board from
its slot.