Removing Continuous Forms Paper; Loading Cut Sheet Paper; Cut Sheet Paper, Top And Front Feed - Oki ML690 User Manual

and
TEAR LF/FF
release the keys.
Continue until the tear-off perforations have been
.
aligned with the paper cutter.
When data is received by the printer or when the
key is pressed to select the printer, the paper will
retract to the new position.

Removing Continuous Forms Paper

Tear off the continuous forms.
1.
Press the
.
LOAD/EJECT
of the continuous forms backwards to the Pin
Tractors.
NOTE:
The printer switches to offline mode. The
ALARM indicator illuminates to indicate that
there is no paper present. If sprocket holes
of the last page of the forms disengage from
the sprocket pins, do not attempt to eject the
paper to avoid the possibility of a paper jam.
Lift the pin tractor covers and remove the forms.
.
Close the pin tractor covers.
.
keys at the same time, then
key to move the front edge

Loading Cut Sheet Paper

There are two methods of loading single sheets of
cut sheet paper, top feed and front feed. See the
following pages for instruction.
SEL

Cut Sheet Paper, Top and Front Feed

Make sure the printer is turned ON.
1.
Note: If there is any continuous forms paper in the
printer, eject it as described in "Removing
Continuous Forms Paper".
Make sure that the
.
avoid the possibility of paper jams.
Place the Paper Type lever in the cut sheet position:
.
To load the cut sheet in the Top Feed Paper tray,
.
raise the top tray.
To load the cut sheet in the Front Feed Paper tray,
open the front cover and install the front paper tray.
Pin Tractor covers are closed to
ML690/ML691 User's Guide