Table of Contents
Advertisement
2.
Check the position of the tear-off perforations (1) relative
to the paper cutter (2). (Paper Tray (3) is shown for
clarity.)
(a)
(b)
NOTE
If a movement greater than +- 7/90 in is specified, the QUIET
indicator blinks and the above adjustment cannot be made.
3.
Release the buttons after the tear-off perforations have
been aligned with the paper cutter.
R
EMOVING CONTINUOUS FORMS
1.
Tear off the continuous forms.
forms" on page 24.
2.
Press the SEL button to set the printer off-line and
reposition the continuous forms in the printer.
3.
Press the PARK button to move the front edge of the
continuous forms backwards to the Pin Tractors.
NOTE
The ALARM indicator illuminates to indicate there is no paper
present.
If sprocket holes of the last page of the forms disengage from
the sprocket pins, do not attempt to eject the paper to avoid
the possibility of a paper jam.
3
To advance the forms, hold down the TEAR button
and press the FF/LOAD button.
To retract the forms, hold down the TEAR button and
press the LF button.
Paper handling > 25
2
1
See "Tearing off continuous
Advertisement
Table of Contents
