Tearing Off Continuous Forms Paper; Aligning The Tear-Off Perforations; Removing Continuous Forms Paper - Oki ML620 User Manual

NOTE: If the TOF position shifts because of taking
up slack, press the LF/FF key to set the TOF
position. Do not use the platen knob for this
option as this will cause irregular line spacing.

Tearing Off Continuous Forms Paper

With the indicator illuminated, press the
1. SEL
key to feed the continuous forms to the tear-off
position.
Carefully tear off the forms along the tear-off
.
perforations in the direction shown.
When data is received by the printer or when
.
the key is pressed to select the printer, the
SEL
continuous forms is repositioned to the first line
print position.

Aligning the Tear-Off Perforations

If the tear-off perforations are not aligned with
the paper cutter on the access cover align them as
follows:
With the indicator illuminated, press the
1.
SEL
button to move the tear-off perforations to the
paper cutter on the access cover.
Check the position of the tear-off perforations
.
relative to the paper cutter. Adjust to the desired
tear-off position using the 1/144" line feeds (LF).
- To move the form forward, press and hold the
and
TEAR
- To move the form backward, press and hold the
and
TEAR
When the tear-off perforations have been aligned
.
TEAR
with the paper cutter, release the keys.
When data is received by the printer or when the
key is pressed to select the printer, the paper will
retract to the new position.

Removing Continuous Forms Paper

Tear off the continuous forms.
1.
Press the
.
of the continuous forms backwards to the Pin
Tractors.
NOTE:
The printer switches to offline mode. The
ALARM indicator illuminates to indicate that
there is no paper present. If sprocket holes
of the last page of the forms disengage from
TEAR
the sprocket pins, do not attempt to eject the
paper to avoid the possibility of a paper jam.
Lift the pin tractor covers and remove the forms.
.
Close the pin tractor covers.
.
keys at the same time.
SEL
keys at the same time.
LF/FF
key to move the front edge
LOAD/EJECT
ML620/ML621 User's Guide
SEL