Testing The Printer; Font Sample Test - Oki ML690 User Manual

Testing the Printer

Font Sample Test


Rolling ASCII Test

Hexadecimal Dump Mode

Font Sample Test
Important!
Wide carriage Model ML691: If you are using 8.5"
paper to run the tests, make sure the paper width
selection in the printer menu is set to 8.5 inches.
Otherwise, printing on the platen may damage
the printer. See Chapter 4: Menu Mode for more
information.
The Font Sample Test prints a sample of the fonts
standard to the printer.
The top of the printout shows the Printer Model,
Emulation (Epson, IBM compatible), Firmware
(F/W) Revision Level, Flash Loader (LD) Revision
Level, and Part Number.
Make sure paper is loaded.
1.
Turn off the printer.
.
Press and hold the
.
the printer back on.
When only the
. SEL
down the key and press the
LF/FF
key.
The printer prints a page of font samples and the
test ends.
keys while turning
SEL + LF/FF
indicator is blinking, hold
LOAD/EJECT
ML690/ML691 User's Guide