Removing Continuous Forms - Oki ML1120 User Manual

3. Check the position of the tear-off perforations (1) relative
to the paper cutter (2).
(a)
(b)
NOTE
If a movement greater than +- 0.366 mm (1/144 in) is
specified, the above adjustment cannot be made.
4. Release the buttons after the tear-off perforations have
been aligned with the paper cutter.
R
EMOVING CONTINUOUS FORMS
1. Tear off the continuous forms.
forms" on page 35.
2. Press the SEL button to set the printer off-line and
reposition the continuous forms in the printer.
3. Press the LOAD/EJECT button to move the front edge of
the continuous forms backwards to the Pin Tractors.
NOTE
If sprocket holes of the last page of the forms disengage from
the sprocket pins, do not attempt to eject the paper to avoid
the possibility of a paper jam.
ML1120/ML1190 User's Guide – Paper handling > 36
To advance the forms, continue to hold down the
TEAR button and then the SEL button.
To retract the forms, continue to hold down the
TEAR button and the LF/FF button.
1
2
See "Tearing off continuous