Bottom Feed (Optional Pull Tractor) - Oki ML690 User Manual

Press and hold the
11.
the paper.
Note: The factory default setting for the Top of Form
(where the printing should begin) is 11/12"
(23.28 mm) down from the top of the page. To
change the setting, see "Top of Form (TOF)".

Bottom Feed (optional pull tractor)

Make sure the printer is turned OFF.
1.
Open the access cover.
.
Adjust the Paper Thickness Lever to suit the
.
paper.
Make sure the Paper Type Lever is in the PULL
.
position.
Place the printer on a slotted printer stand,
.
carefully aligning the slot in the stand with the
slot in the base of the printer.
Place the paper through the slot in the base of
.
the printer.
Bring the paper through the slot in the base of
.
the printer.
key to advance
LOAD/EJECT
Lift the locking lever of the left Pin Tractor and
.
slide the Pin Tractor as required to adjust the
paper position. Then press the locking lever back
down to lock the Pin Tractor.
Lift the locking lever of the right pin tractor and
.
slide the Pin Tractor to the required position to
accommodate the width of the continuous forms
to be used. Move the paper guide to midway
between the left and right Pin Tractors.
Open the left and right Pin Tractor covers and
10.
feed the continuous forms in the direction of the
arrow, loading the sprocket holes in the forms
onto the sprocket pins.
NOTE: Make sure that paper is fed straight into the
printer to avoid the possibility of skew printing,
irregular line feeding and paper jams.
Make sure that the forms are properly aligned
11.
on the sprocket pins, then close the Pin
Tractor covers. Adjust the right Pin Tractor to
accommodate the width of the continuous forms,
taking care that the forms are held neither too
loosely nor too tightly between the Pin Tractors.
Press the locking lever down to lock the right Pin
Tractor in the desired position.
NOTE: Make sure that the continuous form is pulled
ML690/ML691 User's Guide
1