Table 5.11
Set Time and Date on Controller
Convention
MegaCli –AdpSetTime yyyymmdd HH:mm:ss -aN|-a0,1,2|-aALL
Description
Sets the time and date on the controller. This command uses a 24-hour format.
For example, 7 p.m. displays as 19:00:00. The order of date and time is reversible.
5.4.10
Display Time and Date on Controller
Table 5.12
Display Time and Date on Controller
Convention
MegaCli –AdpGetTime -aN
Description
Displays the time and date on the controller. This command uses a 24-hour format.
For example, 7 p.m. would display as 19:00:00.
5.5
Patrol Read-Related Controller Properties
5.5.1
Set Patrol Read Options
Use the command in
selected controller(s).
You can use the commands in this section to select the settings for Patrol
Read. A Patrol Read scans the system for possible drive errors that could
lead to drive failure, then takes action to correct the errors. The goal is
to protect data integrity by detecting drive failure before the failure can
damage data. The corrective actions depend on the virtual drive
configuration and the type of errors. Patrol Read affects performance; the
more iterations there are, the greater the impact.
Use the command in
Patrol Read options.
Patrol Read-Related Controller Properties
Table 5.12
to display the time and date on the
Table 5.13
on the selected controller(s) to set the
5-11