Vlan; Application Settings (Spa122 Only); Quality Of Service (Qos) (Spa122 Only) - Cisco SPA112 Administration Manual

Configuring the Network

Application Settings (SPA122 Only)

Application Settings (SPA122 Only)
Cisco SPA100 Series Phone Adapters Administration Guide
Field
L2TP Passthrough

VLAN

Use the Network Setup > Advanced Settings > VLAN page to assign a VLAN ID
to your network. The VLAN ID can be any numeral from 3 to 4094. The default
value is 3.
To open this page: Click Network Setup in the menu bar, and then click
Advanced Settings > VLAN in the navigation tree. After making changes, click
Submit to save your settings, or click Cancel to abandon any unsaved entries.
Use the Network Setup > Applications Settings pages to support voice service
and any servers that you host for public access.
• Quality of Service (QoS) (SPA122 Only), page 28
• Port Forwarding (SPA122 Only), page 29
• DMZ (SPA122 Only), page 33

Quality of Service (QoS) (SPA122 Only)

Use the Network Setup > Application > QoS page to set the upstream bandwidth
to suit your broadband service. This feature is enabled by default and helps to
ensure that voice is prioritized during periods of heavy network traffic.
To open this page: Click Network Setup in the menu bar, and then click
Application > QoS in the navigation tree.
Description
Layer 2 Tunneling Protocol is the method used to enable
Point-to-Point sessions via the Internet on the Layer 2
level. Click Enabled to enable this feature, or click
Disabled to disable it. The default setting is Enabled.
The default setting is Enabled.
3
28