Internet Settings - Cisco SPA112 Administration Manual

Configuring the Network
Basic Setup
Cisco SPA100 Series Phone Adapters Administration Guide

Internet Settings

Use the Network Setup > Basic Setup > Internet Settings page to set up your
Internet connection.
To open this page: Click Network in the menu bar, and then click Basic Setup
> Internet Settings in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Internet Connection Type
Field
Connection Type
Static IP Settings
Description
Specify the Internet addressing method that your ISP
requires. The default setting is Automatic
Configuration - DHCP.
• Automatic Configuration - DHCP: Use this
setting if your ISP dynamically provides an IP
address.
• Static IP: Use this setting if your ISP assigned a
static/permanent IP address.
• PPPoE (DSL service): Some DSL-based ISPs
use PPPoE (Point-to-Point Protocol over Ethernet)
to establish Internet connections. If you are
connected to the Internet through a DSL line,
check with your ISP to see if they use PPPoE.
• Internet IP Address and Subnet Mask: Enter the
IP address and subnet mask that was assigned to
your account by your service provider. This
address is seen by external users on the Internet.
• Default Gateway: Enter the Gateway IP Address
that was provided by your ISP.
Also: Enter the MTU, as described in this table, and see
Optional Settings, page 19.
3
17