Snmp - Cisco SPA112 Administration Manual

Administration Settings
Management
Cisco SPA100 Series Phone Adapters Administration Guide
Field
Periodic Inform
Interval
Periodic Inform
Enable
Request Download

SNMP

Use the Administration > Management > SNMP page to set up Simple Network
Management Protocol (SNMP) for the ATA.
SNMP is a network protocol that allows network administrators to manage,
monitor, and receive notifications of critical events as they occur on the network.
The ATA supports SNMPv2 and SNMPv3. It acts as an SNMP agent that replies to
SNMP commands from SNMP Network Management Systems. It supports the
standard SNMP get, next, and set commands. It also generates SNMP traps to
notify the SNMP manager when configured alarm conditions occur. Examples
include reboots, power cycles, and INTERNET (WAN) events.
To open this page: Click Administration in the menu bar, and then click
Management > SNMP in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Settings for SNMPv2
Field
Enabled, Disabled
Trusted IP
Get Community
Description
The periodic inform interval. The default value is 86400
seconds.
Click Enabled to enable this feature, or click Disabled to
disable it.
If applied, ACS may call the Download RPC after it
receives the request from the ATA.
Description
Click Enabled to enable this feature, or click Disabled to
disable it. The default setting is Disabled.
Choose Any to allow access from any IP address (not
recommended). Click Address to specify the IP address
and subnet mask of a single SNMP manager or trap
agent that can access the ATA through SNMP.
Enter a community string for authentication for SNMP
GET commands. The default value is public.
5
119