Cisco SPA112 Administration Manual page 81

Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide
Field
Call Back Retry Intvl
Call Back Delay
VMWI Refresh Intvl
Interdigit Long Timer
Interdigit Short Timer
CPC Delay
Description
Call back retry interval in seconds. Range: 0–255
seconds. Default setting: 30.
Delay after receiving the first SIP 18x response before
declaring the remote end is ringing. If a busy response is
received during this time, the ATA still considers the call
as failed and keeps on retrying. Default setting: 0.5.
Interval between VMWI refresh to the device. Default
setting: 0.
Long timeout between entering digits when dialing. The
interdigit timer values are used as defaults when dialing.
The Interdigit_Long_Timer is used after any one digit, if
all valid matching sequences in the dial plan are
incomplete as dialed. Range: 0–64 seconds. Default
setting: 10.
Short timeout between entering digits when dialing. The
Interdigit_Short_Timer is used after any one digit, if at
least one matching sequence is complete as dialed, but
more dialed digits would match other as yet incomplete
sequences. Range: 0–64 seconds. Default setting: 3.
Delay in seconds after caller hangs up when the ATA
starts removing the tip-and-ring voltage to the attached
equipment of the called party. The range is : 0–255
seconds. This feature is generally used for answer
supervision on the caller side to signal to the attached
equipment when the call has been connected (remote
end has answered) or disconnected (remote end has
hung up) This feature should be disabled for the called
party (in other words, by using the same polarity for
connected and idle state) and the CPC feature should
be used instead.
Without CPC enabled, reorder tone will is played after a
configurable delay. If CPC is enabled, dial tone will be
played when tip-to-ring voltage is restored. Resolution is
1 second.
The default range is 2.
4
81