Dial Plan Timer (Off-Hook Timer) - Cisco SPA112 Administration Manual

Configuring Voice
Configuring Dial Plans
Cisco SPA100 Series Phone Adapters Administration Guide
Terminating Event
A timeout occurs.
The user presses the #
key.

Dial Plan Timer (Off-Hook Timer)

You can think of the Dial Plan Timer as "the off-hook timer." This timer starts
counting when the phone goes off hook. If no digits are dialed within the specified
number of seconds, the timer expires and the null entry is evaluated. Unless you
have a special dial plan string to allow a null entry, the call is rejected. Default
setting: 5
Syntax for the Dial Plan Timer
(Ps<:n> | dial plan )
• s: The number of seconds; if no number is entered after P, the default timer
of 5 seconds applies.
• n: (optional): The number to transmit automatically when the timer expires;
you can enter a valid number. No wildcard characters are allowed because
the number will be transmitted as shown. If you omit the number
substitution, <:n>, then the user hears a reorder (fast busy) tone after the
specified number of seconds.
Processing
The number is rejected if the dialed digits are not
matched to a digit sequence in the dial plan within
the time specified by the applicable interdigit timer.
• The Interdigit Long Timer applies when the
dialed digits do not match any digit sequence
in the dial plan. Default setting: 10 seconds
• The Interdigit Short Timer applies when the
dialed digits match one or more candidate
sequences in the dial plan. Default setting: 3
seconds
• If the sequence is complete and is allowed by
the dial plan, the number is accepted and is
transmitted according to the dial plan.
• If the sequence is incomplete or is blocked by
the dial plan, the number is rejected.
4
48