Advanced > Security > Secure Protocols - Kyocera FS-2100DN User Manual

Advanced > Security > Secure Protocols
COMMAND CENTER RX
• %serial = Serial Number
• %etheraddr = MAC Address
SSFC Job Log Subject
Defines the Job Log Notification information reports only when you log in by
using a SSFC-format IC card. You can include the same information as
above. (This menu available when an optional IC-card reader is installed
with the printing system.)
Auto Sending
Determines whether the job log report is sent or not. Set this to On to send
the report.
Jobs
Set the number of job logs for sending, from 1 to 1500.
Run once now
You can test this by clicking the Send button to immediately send a report.
You can encrypt communication between a PC and this machine using SSL
encryption. For the changes made in the following to take effect, restart the
network or this machine as described in
SSL
Specifies whether or not to use the SSL protocol.
Serverside Settings
• Effective Encryption
Selects the encryption algorithm(s) to be used from DES, 3DES, and AES.
• HTTP Security
Specifies the security level.
• Secure Only (HTTPS)
Encrypts all HTTP protocol communication. Access is possible only with a
URL that begins with "https://." Access attempts using an ordinary http://
URL are automatically redirected to the URL where "http://" is replaced
with "https://."
• Not Secure (HTTPS & HTTP)
Enables access for both encrypted and unencrypted HTTP protocol
communication. Access is possible with https:// and http:// URLs. The
former URL establishes encrypted communication and the latter
establishes normal communication.
IPP Security
Specifies the security level.
• Secure Only (IPPS)
Encrypts all IPP protocol communications.
• Not Secure (IPPS & IPP)
Enables access for both encrypted and unencrypted IPP protocol
communications.
Clientside Settings
Basic > Defaults > Reset
Settings Pages
on page 6-6.
6-49