Communication Timeout; Snmp Communication Retries; Secure Protocol Settings; Login Settings - Kyocera TASKalfa 3050ci User Manual

2. Click Device > Device Home Page in the menu bar.
3. Login to the device from the Command Center, and click the
4. To the left of the page, under Protocols, select TCP/IP and
A restart may be required for logical printer changes to take effect.
Use the Reset page in the Command Center Basic tab.
Note: In older models, set the port number from the device home
page. Select Networking > Logical Printers. To restart, select
General > Reset.

Communication Timeout

Enter the number of seconds the server should wait for the printing
device to respond to an SNMP or SOAP request. The available
range is from 5 to 120 seconds.

SNMP Communication Retries

Enter the number of times, after an initial failure, the application
should attempt to establish SNMP communication with the printing
device. The available range is from 0 to 5 retries. A higher number
will increase network traffic, while a lower number can improve
performance.

Secure Protocol Settings

Secure Sockets Layer (SSL) is a cryptographic protocol that provides
security for network communications. SSL support varies by network
interface model.
Select SSL to use HTTPS for device communication.
Clear SSL to use HTTP for device communication.

Login Settings

The Login section lets you set user login information. The feature can
be set if at least one selected device supports the User Login feature.
KMnet Viewer 5.2
Advanced tab at the top of the page.
then select Logical Printers. The TCP/IP port is displayed
for each logical printer. One of these logical printer ports
must match the port number entered in Communication
Settings.
62