Basic > Defaults > Reset; Basic > Defaults > Device Defaults - Kyocera FS-2100DN User Manual

Settings Pages
Basic > Defaults > Reset
Basic > Defaults > Device Defaults
1
2
3
6-6
This page allows you to restart the machine in order to make all settings in the
machine valid. It is also possible to select to have all settings returned to their
factory default values.
Restart entire device
Clicking Restart restarts this machine.
Restart Network
Clicking Restart allows restarting the network interface without restarting the
machine. The network interface must be restarted whenever a change has
been made to the network settings.
Reset entire device to factory default
When clicking the Reset button, the machine returns to the factory default
settings. However, the document box, address book, user information, logs,
and certificates are not deleted.
This page allows you to change the language that is used in the display, to turn
Auto Sleep Mode on or off, etc.
Operation Panel Language
You can select the language of the messages on the display by following the
procedure given below. The following languages are available for selection
in the drop down list: English, Français, Deutsch, Italiano, Nederlands,
Español, Português, Russian, and the downloaded languages. You can
optionally download messages in other languages. Contact your dealer for
information. Some models may require restarting after configuration.
Sleep Timer
Specify the time in the drop-down list, from 1 to 240 minutes, after that the
system enters Auto Sleep Mode. On some models, you can choose how the
machine wakes up and reverts to normal mode of operation in Quick
Recovery or Energy Saver as described below.
Proceed as follows to complete sleep mode settings:
Click Advanced on the right hand side of the Sleep Timer drop-down list.
Note: Advanced settings are not available when a FAX Kit is installed in the
machine.
Turn Auto Sleep On or Off. If you select Off, Sleep Timer is disabled and the
machine will not enter sleep mode.
In Sleep Level, select Quick Recovery or Energy Saver.
Quick Recovery automatically lets the machine recover from sleep mode when
the machine receives a print data via any interface (network, USB port, etc.).
With Energy Saver, printing does not take place until you make a key operation
on the machine operator panel.
Alternatively, on some models, the Sleeping page appears on the embedded
web server while the system is engaged in Energy Saver. You can click Start on
the Sleeping page.
User Guide