Advanced > Protocols > Tcp/Ip > Logical Printers - Kyocera FS-2100DN User Manual

Advanced > Protocols > TCP/IP > Logical Printers
COMMAND CENTER RX
To allow access to a network, enter the network IPv4 address, and the
subnet mask. For example: To allow access from all hosts on network 192,
enter "192.0.0.0" for the IP address, and "255.0.0.0" for the subnet
mask. Subnet mask can also be left blank.
To allow access to a single IP address, enter the IPv4 address, and
"255.255.255.255" for the subnet mask.
• Protocols
Specifies the protocol to be permitted. The following protocols can be
selected:
• LPD
• FTP
• IPP
• ThinPrint
• HTTP
• Raw
• SNMP
• IPP over SSL
• HTTPS
IP Filters (IPv6)
• IP Address (IPv6)
Specifies the IP addresses to which access is granted. When there are no
entries, access is allowed to all. The number of addresses that can be
specified depends on the IPv6 network address along with the prefix length
setting. To filter a single IPv6 address: Enter the desired IPv6 address, along
with a prefix length of 128.
• Prefix Length
Specifies the IPv6 prefix length. It can be a decimal value between 0 and 128.
• Protocols
Specifies the protocols through which access is granted. The following
protocols can be selected.
• LPD
• FTP
• IPP
• ThinPrint
• HTTP
• Raw
• SNMP
• IPP over SSL
• HTTPS
This page allows you to configure the Logical Printers. This machine can be
used as a virtual printer for converting ASCII print data to PostScript data or for
adding and/or replacing character strings (commands) at the beginning or end
of job data. Up to four logical printers can be set.
Settings Pages
6-35