Kyocera FS-2100DN User Manual page 31

4
1
2
3
COMMAND CENTER RX
If you have selected Energy Saver mode of sleeping, click On of the appropriate
radio button for the interface or device you would like to engage in Energy
Saver. Click Off if you do not want to engage Energy Saver for the interface or
device. For example, if you want print data received by the network interface to
automatically wake the machine and be printed, click Off next to Network.
Click Submit.
Power Off Timer
This feature is incorporated with some models. It automatically turns off the
machine in the absence of data for a predetermined time interval. This will
conserve more energy that the machine uses. You can manage the interval
and conditions that the power off timer is activated as follows:
From the drop-down list, select the time interval after which the device engages
in power-off state, from 1 hour to 1 week.
Click Advanced to open Power Off Rule.
Select the interface or device which you want to activate (On) or deactivate
(Off) the power-off timer.
Override A4/Letter
Specifies whether or not the A4 and Letter size paper should be
interchangeable. When turned On, for example, if the A4 paper is not in the
tray, the Letter size paper will be selected for printing. When turned Off, the
Letter size paper will not be used in place of the A4 paper, when A4 is
selected for printing but the A4 tray is empty.
Auto Error Clear
Turns Auto Error Clear, which automatically clear errors when they occur, on
or off.
Error Clear Timer
Specifies the time between 5 and 495 seconds after which errors are cleared
automatically.
Low Power Timer
Specifies the time from 1 to 240 minutes after which the system enters the
low power mode, where it reduces the power consumption.
Interrupt Clear Time
This determines the time period before the machine reverts to normal mode,
after the interrupt copy mode has been engaged. The range is 5 to 459
seconds (in 5-second increments).
WSD Scan Timer
This determines the time period before the machine reverts to normal mode,
after WSD scan mode has been engaged. The range is 10 to 495 seconds
(in 5-second increments).
RAM Disk Mode
Specifies whether to use a part of the print system memory as a RAM disk.
You can specify the size of the print system memory to use for the RAM disk.
If this item is On, electronic sorting is enabled and the printing speed
increases. After you have changed the setting, you must restart the printing
system.
Settings Pages
6-7