Advanced > Management > Notification/Maintenance > Maintenance Notification; Advanced > Management > Maintenance Notification > Sending Log History - Kyocera FS-2100DN User Manual

Settings Pages
Advanced > Management > Notification/Maintenance >
Maintenance Notification
Advanced > Management > Maintenance Notification > Sending
Log History
6-48
These items are used when FeliCa is selected in IC Card Read Type. Each
item must be given a specific parameter for the FeliCa IC card to use.
This feature defines the recipient of maintenance information reports.
Equipment ID
This is the name by which the machine will be identified.
Recipient Address
The E-mail address of the recipient. If there is more than one recipient then
the addresses should be separated by a semicolon ";".
Subject
You can include model name, serial number, MAC address and equipment
ID in the subject line as follows: Enter one of the following conversion strings
starting with %. The string will be converted into a pre-defined string to
display the above information.
• %printer = Model
• %serial = Serial Number
• %etheraddr = MAC Address
• %equipid = Equipment ID
E-mail Interval
Sets the time or interval for sending the status information. Events will be
reported at the specified interval.
• None: No report is sent.
• Monthly: Sends on the specified time of the specified month.
• Weekly: Sends on the specified time of every week.
• Daily: Sends at the specified time of every day.
• Hourly: Sends at the specified interval every hour.
If a specified day does not exist in the month, such as the 31st, the last day
of the month is used as the specified day.
Run once now
You can test this by clicking the Send button to immediately send a report.
This feature defines the Job Log Notification information reports.
Recipient Address
The E-mail address of the recipient. If there is more than one recipient then
the addresses should be separated by a semicolon ";".
Job Log Subject
You can include model name, serial number, and MAC address in the
subject line as follows: Enter one of the following conversion strings starting
with %. The string will be converted into a pre-defined string to display the
above information.
• %printer = Model
User Guide