Advanced > Management > Authentication > Network User Property - Kyocera FS-2100DN User Manual

Settings Pages
Advanced > Management > Authentication > Network User
Property
6-46
Enter the host name of the Windows domain controller when Network
Authentication is specified as Authenticate Mode.
Port Number
Use the numeric keypad to type the port number when the Server Type
below is Ext(ernal).
Server Type
This specifies the authentication method used by the domain controller when
Network Authentication is enabled. Select NTLM when the domain
controller is Windows NT, Kerberos for Windows 2000 Server or Windows
Server 2003, or Ext(ernal).
Domain Name
When Network Authentication is enabled, enter up to 10 domain names.
You can select one of these domains at login. Select the Default radio
button to the left of a domain name which you want to make the default
domain.
Note: The default domain should be the one which belongs to the host
specified in Host Name.
Keyboard Login
This determines whether login authentication is allowed via the machine
operation panel or not, despite the IC card authentication is activated (using
the IC card authentication kit installed).
This allows to obtain user information at authenticating the user over the
network. The LDAP protocol must be enabled in order to obtain user
information.
Obtain Network User Property
Turned On to obtain user information.
LDAP Server Name
Specifies a host name or IP address for the LDAP server.
LDAP Port Number
Specifies a port number for LDAP or use the LDAP default port 389.
Search Timeout
Specifies a period of time for searching the LDAP server.
LDAP Security
Selects the type of encryption according to the type of security employed by
the LDAP server. Select Off when encryption is not used.
Authentication Type
Selects either the Simple or SASL for the authentication type.
Name 1 (2)
Specifies the LDAP attribute to obtain a user name for display, from the
LDAP server. The default for Name 1 is displayName.
E-mail Address
Specifies the LDAP attribute to obtain an E-mail address from the LDAP
server. The default is mail.
User Guide