Advanced - Protocols - Tcp/Ip - Logical Printers - Kyocera COMMAND CENTER Multifunctional Printer Operation Manual

COMMAND CENTER Pages
Advanced > Protocols > TCP/IP > Logical Printers
36
Item
Protocols
IP Filters (IPv6)
IP Address
(IPv6)
Prefix
Length
Protocols
This page allows you to configure the Logical Printers. This machine can be used as a
virtual printer for converting ASCII print data to PostScript data or for adding and/or
replacing a character strings (commands) at the beginning or end of job data. Up to four
logical printers can be set.
Each logical printer can be used with either the FTP, LPR, IPP, NetBEUI, or Raw Port
protocol. All printout to a non-existent port will be accomplished to Logical Printer1.
Item
TCP/IP Port
Number
Bi-directional
Printing
Description
Specifies the protocol to be permitted. The following
protocols can be selected.
- LPD
- FTP
- IPP
- HTTP
- SNMP
- RAW Port
- IPP over SSL
- HTTPS
Specifies the IP addresses to which access is granted. The
number of addresses that can be specified varies depending
on the model used.
Specifies the IPv6 prefix length. It can be a decimal value
between 1 and 128.
Specifies the protocols through which access is granted.The
following protocols can be selected.
- LPD
- FTP
- IPP
- HTTP
- RAW Port
- SNMP
Description
Specifies the port number for the logical printer as well as
the TCP raw port number (9100, etc.). Conversion is applied
to data that is input to the specified raw port in accordance
with the selected logical printer. This port is invalid if it is
given a port number that is the same as that of an already
specified port (e.g. FTP or LPD).
On or Off Bi-directional Printing using the TCP/IP raw port.
With this setting Off, all send data are discarded.
In order to have the data that is received from the printer
returned to the client when printing with PostScript, PJL and
other such commands, it is necessary to On bi-directional
printing.
KYOCERA COMMAND CENTER