To determine the status of a WWN card:
1.
Check the LED indicators on the WWN bezel and verify that they reflect the actual status of the
components. The WWN bezel covers the WWN cards and allows its LEDs to shine through. The
LEDs on the WWN bezel provide a consolidated view of the port, CP, and CR blade status (see
Table
16).
If a blade slot has a filler panel installed, the corresponding LEDs on the WWN card do not light
up.
Table 16 WWN LED patterns
LED location/purpose
Director blade/CP/CR
blade power
Director blade/CP/CR
blade status
NOTE:
If a status LED on the WWN bezel flashes, the power LED on the WWN bezel also flashes,
for increased visibility.
2.
Check the WWN card status using the commands listed in
modifying this data could indicate a WWN card failure.
Table 17 Commands identifying the WWN card status
To check the:
WWN values
Data about the chassis and WWN card
Ethernet and Fibre Channel IP address information for
the CP blades
History log information
Name of switch
92
Replacing DC SAN Director field-replaceable units (FRUs)
Color
Status
Steady green
Power is okay.
Steady amber
Card is faulty.
No light (LED is off)
Card is okay.
Recommended action
No action required
Check card.
No action required
Table
17. Difficulty retrieving or
Using the following commands
wwn, chassisShow
chassisShow
ipAddrShow, ipAddrSet
historyShow, historyLastShow
switchName