Powering On The Dc04 San Director; Installing The Dc04 San Director With Shipping Brackets - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual
Hp storageworks dc and dc04 san backbone director switches hardware reference guide (5697-7814, february 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- User manual (248 pages) ,
- Release note (76 pages)
Table of Contents
Advertisement
Figure 47 Installing the DC04 SAN Director with shipping brackets
Powering on the DC04 SAN Director
CAUTION:
Use the power cords supplied. Ensure that the facility power receptacle is the correct type, supplies
the required voltage, and is properly grounded.
To power on the DC04 SAN Director:
1.
Connect the AC power cords to the power supply assemblies. One to four power cords are
required, depending on electrical service.
2.
Connect the power cords to a power source with voltage of 200 to 240 VAC, 47 to 63 Hz
(normally two power cords) or to a power source with voltage of 110 to 120 VAC, 47 to 63 Hz
(two to four power cords).
TIP:
Use of the high-voltage line (200 to 240 VAC) is highly recommended due to better
power-conversion efficiency
138
DC04 SAN Director Installation
Advertisement
Table of Contents
