10 Replacing DC04 SAN Director
field-replaceable units (FRUs)
This chapter provides information for replacing the following components:
IMPORTANT:
The FRUs in the DC04 SAN Director can be removed and replaced without special tools. The DC04
SAN Director can continue operating during many of the FRU replacements if the conditions specified
in the procedure are followed.
• "Replacing the chassis
• "Replacing the vertical cable management
• "Replacing DC04 Director port and application
• "Replacing a blade filler
• "Replacing a control processor blade
• "Replacing a core switch blade
• "Replacing a power
• "Replacing a blower
• "Replacing the WWN bezel (logo plate) and WWN
• "Replacing SFPs and
• "Replacing the DC04 Director
Replacing the chassis door
The chassis door must be installed to ensure that the DC04 SAN Director meets EMI and other
regulatory certifications. The replacement procedure for the chassis door takes less than 5 minutes.
Removing the chassis door
To remove the chassis door (see
NOTE:
The door is not hinged. It is installed straight on the chassis by snapping four ball studs located on
the chassis into receiving hardware on the door in the cabinet.
1.
Grip the side of the door. Support the door to prevent it from falling.
2.
Gently pull the door straight out from the chassis until it snaps out of the ball studs on the chassis.
door" on page 169
assembly" on page 170
panel" on page 174
(CP8)" on page 175
(CR4S-8)" on page 181
supply" on page 184
assembly" on page 185
XFPs" on page 192
chassis" on page 193
Figure 63
on page 170):
HP StorageWorks DC and DC04 SAN Backbone Director Switches
blades" on page 171
card" on page 187
169