Fibre Channel Port Specifications; Dc04 San Director Environmental Requirements - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual

Condition
Vibration
Air flow
Heat dissipation
Table 51 DC04 SAN Director environmental requirements
Condition
Ambient temperat-
ure
Humidity
Altitude
Shock
Vibration
Air flow
Heat dissipation
NOTE:
The 10° to 40° Celsius range applies to the ambient air temperature at the air intake vents on the
non-port side of the DC SAN Director or DC04 SAN Director. The temperature inside the product
chassis can be up to 75° Celsius during operation. If the internal temperature range exceeds the
operating ranges of the components, the LEDs, error messages, and Fabric Watch alerts will indicate
a problem. Use the tempShow command or Fabric Watch commands to view temperature status.

Fibre Channel port specifications

The Fibre Channel ports in the DC SAN Director and DC04 SAN Director support full duplex link
speeds at 10.51875, 8.50, 4.25, 2.125, or 1.0625 Gb/s inbound and outbound, automatically
negotiating to the highest common speed of all devices connected to the port.
The ports are compatible with optical SWL (short wavelength: approximately 850 nm), optical LWL
(long wavelength: approximately 1310 nm), and Extended Long Wavelength (ELWL) laser transmitter
SFPs and XFPs (FC10-6 only) (approximately 1550 nm). The strength of the signal is determined by
the type of SFP or XFP in use.
220 Technical specifications
Acceptable range during operation
1G p-p, 5-500 Hz at 1.0 octave/minute
350 cu ft/min. (0.00059 cu m/hr)
1440 Watts or 4914 BTU (Eight FC8-48
blades and two CP8 blades)
Acceptable range during operation
10° to 40° C outside switch (50° to 104° F)
5% to 85% RH noncondensing, at 40° Celsius,
with maximum gradient of 10% per hour
Up to 3 km (10,000 ft.) above sea level
20G, 6ms duration, half-sine wave
0.5G p-p, 5-500 Hz at 1.0 octave/minute
350 cu ft/min. (0.00059 cu m/hr)
841 Watts or 2869 BTU/hr (Four FC8-48
blades, two CP8 blades, and two CR4S-8
blades)
Acceptable range during non-oper-
ation
2.4G p-p, 5-500 Hz at 1.0
octave/minute
None required.
Not applicable.
Acceptable range during non-oper-
ation
-40° to +70° C outside switch (-40° to
158° F)
10% to 93% RH noncondensing, at
70° Celsius
0 to 12 km (40,000 ft.) above sea
level
33G, 11ms duration, half-sine wave
2.0G p-p, 5-500 Hz at 1.0
octave/minute
None required.
Not applicable.