Removing A Blower Assembly; Installing A Blower Assembly - HP A7533A - Brocade 4Gb SAN Switch Base Hardware Reference Manual
Hp storageworks dc and dc04 san backbone director switches hardware reference guide (5697-7814, february 2009)
Hide thumbs
Also See for A7533A - Brocade 4Gb SAN Switch Base:
- Administrator's manual (576 pages) ,
- User manual (248 pages) ,
- Release note (76 pages)
Table of Contents
Advertisement
Removing a blower assembly
To remove a blower assembly:
CAUTION:
Wear a grounded ESD strap when handling DC04 SAN Director components. The Director chassis
provides a grounding connection above the power connectors. Also, store ESD-sensitive components
in antistatic packaging.
1.
Before removing a blower assembly, verify that the other blower assembly is functioning correctly.
The power LEDs should be steady green.
2.
Use the screwdriver to loosen the captive screws at the left and right of the blower assembly.
3.
Grasp the handle and pull, sliding the blower assembly from the chassis and supporting the
blower assembly from beneath as you remove it (see
Installing a blower assembly
To install a blower assembly
1.
Orient the blower assembly and slide it into the chassis, pushing firmly to ensure that it is seated.
2.
Verify that the power LED displays a green light.
3.
Use the screwdriver or your fingers to tighten the captive screws.
186
Replacing DC04 SAN Director field-replaceable units (FRUs)
Figure
71).
Advertisement
Table of Contents
